Skutch-electronics T-700 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Skutch-electronics T-700. Skutch Electronics T-700 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Installation
Follow the four steps below for connection to your single or two-line
telephones.
Operation
To place a call on hold
Do
NOT
press the hold button!!...simply press
*
and hang up the
phone. The caller will hear the audio source that you have connected to the
adapter. Note: if you do not hang up your phone within 4 seconds, the
adapter will automatically reset.
To release the hold condition
Pick up any phone that is connected to that line and the adapter will
automatically release the call.
Troubleshooting Guide
Open the lid by removing the 4 Phillips head screws; you will see the
circuit board to the right.
Lights on phone don't work when on hold
Change the "LIGHT SWITCH" to a different position. Try all three
positions if necessary. (see below)
No Audio
Open lid. Pick up phone and press the
*
key. The red LED for the
line you are on, in the T-700, (see below) should light for about 4 seconds.
Audio should be heard through the ear piece of the telephone. If no audio is
heard check the following:
!
Make sure the audio source is playing.
!
Make sure the volume on the audio source is turned up.
!
Make sure that the audio cable is connected from the headphone
output of the audio source, to the audio jack on the T-700. Make
sure the type of jacks on the cable are the correct type. (male
phono or RCA for the T-700).
Music does not shut off when phone picked up
Open lid. Change the "LIGHT SWITCH" to a different position. Try all
three positions if necessary.
Music cuts off after placing call on hold
Hang the phone up after pressing the
*
key, do not press the hold
button on your telephone.
Phone Jack
AC Outlet
Plug "T Adapter"
into phone jack.
Connect Phone and
T-700 to "T Adapter"
1
Plu
g
T-700 into
120V Wall Outlet.
Connect audio cable from
T-700 to Audio Source.
2
3
4
Audio Source
1 2 3
Vue de la page 0
1 2

Résumé du contenu

Page 1 - • Troubleshooting Guide

• InstallationFollow the four steps below for connection to your single or two-linetelephones.• Operation• To place a call on holdDo NOT press the h

Page 2 - ONE YEAR LIMITED WARRANTY

Tech Support - 916-786-6186If you have any problems getting the T-700 to work properly feel free togive us a call. Technical Support is available bet

Commentaires sur ces manuels

Pas de commentaire